Assembly instruction for the Windkat
Safety regulations without requirement on completeness
> to safe ascent to the fire-place pay attention
> on firm conditions is to be respected
> on reliable safety against falling is to be respected
> when transport and assembling of the Windkats protective gloves wear
> the Windkat is only on intact, i.e. do not mürben fire-place heads to install
> for firm seat of the pegs absolutely is to be taken care
> possibly for additional lightning protection provide
Assembly
Scope of supply: Diverting head, mounting plate with interior pipe, 4 pieces of pegs 6 mm and 4 pieces suitable screws
Tool: Percussion drill, 6mm stone drill, extension cord and suitable screwdrivers
> diverting head (1) from mounting plate take off (2). Mounting plate on the fire-place set and at the fire-place internal dimension align. The intended fastening spots (3) mark. Mounting plate from the fire-place remove and mounting holes (6 mm) bore. Enclosed pegs into mounting holes put.
> important!
Mounting plate approximately around the flue gas outlet with heatproof silicone hose down, so that no wrong course can penetrate into the Windkatsystem. Mounting plate with the settled screws into mounting holes bored before bolt on.
> Abströmkopf push (1) over the tube ends of the mounting plate. The diverting head fastens itself by the Winddüsen. A further attachment is not necessary.
Finished!! The Windkatsystem is now operational
General references:
The Windkatsystem requires in principle no build-legal permission. The partially different fire plant regulations of the countries are to be considered. When inappropriate assembling, e.g. mürbem fire-place head, and the associated damage no adhesion is taken over.
The firm tightness of the Windkats is to be examined in regular time intervals.
During the fire-place cleaning, no special measures are to be considered concerning the Windkats.
To be opened when the burning out out gloss soot the Windkat is the dust cover to be removed or.
